Auto Ads by Adsense

Tuesday, December 16, 2014

Review: Garmin Inertia-based Speed and Cadence Sensor

My frustrations with the GSC 10 grew to the point where I'd pretty much given up on it, leaving it turned off on my single bike. I lived with it like this for a while, since I don't really need the cadence information, but having speed jumps all over the place and not having consistent speed readings was bothersome.

You can buy the speed/cadence inertia based sensors separately, but the package gives you $10 off. At $70, this is not cheap, but given the longevity of my other Garmin products, it seemed like a pretty safe bet.

The package comes with 2 sensors, one fat and short, and one long and skinny. The fat one goes around your front hub (or rear, if you like to use your bike on a trainer), while the skinny one goes on your crank. You pair it by selecting the speed and cadence sensor option (or just one or the other if you bough tone), and then ride off. It's as painless as it gets.

There is only one potential issue with the cadence sensor, which is that if you tend to scuff your crank, you might eventually wear out the rubber band. That's not a big deal for me, but it could lead to a loss of a sensor, which is expensive.

Both sensors take the CR2032 battery, the same as the heart rate monitors. That's very considerate of Garmin, and ensures that I can just stock one battery for most Garmin products.

Assuming that this sensor's going to be as reliable as other Garmin products, the replacement for the GSC 10 is much better and a worthy upgrade. Recommended.

No comments: